Eowave Eobody1 Uživatelský manuál stáhnout pdf (Strana 13)

manual ©eowave/Ircam 2003

user’s manual

• IV.3. - Use eo•body Editor

IV.3. First step with eo•body editor

When opening eo•body editor window, no parameters are set. To modify the configuration

from eo•body, you may first transfer its memory into the editor or recall a preset configura-

tion already stored on your hard drive. To proceed to this transfer, you need a bi-directional

MIDI connection with the MIDI out from your computer connected to the MIDI in from

eo•body & the MIDI out from eo•body connected to the MIDI in from the computer. Ensure

that you are using the same port on eo•body.

The «request» button from the editor enables to send a message to eo•body to dump

eo•body ’s memory. eo•body ’s memory contains will be dumped and its information will be

displayed on the 1-8 Inputs Window, 9-16 Inputs Window or Knobs & Switches Window.

You may proceed to the modification from your configuration in two steps :

First, modify the parameters from your configuration directly on the editor. Secondly, dump

your new configuration into eo•body.

Once the modifications are stored, you may test your configuration with the Input Monitor

Window from the eo•body editor : each bargraph shows the activity from each input.

Note : 10 bits data are not represented by the Input Monitor Window.

Once tested, unplug eo•body ’s connection from the computer.

eo•body has a non-volatile memory. You may also store your configurations onto your hard

drive & recall them when desired.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Žádné komentáře

Eowave Eobody1 Uživatelský manuál Strana 13